25G - AGMT - BOARD- UP SRVS - Laserfiche WebLink

Home Browse Search

BARRIER ASSEMBLY I. Plywood shall be cut to fit over the window and door openings, flush with outside of the molding/trimmer stud. Application of barriers shall be completed so that all lift or pry points are avoided. Plywood board shall be solid sheets without seams or joints. 2. The 2x4 braces shall be cut to fit the horizontal dimension of the plywood. Two exterior and two interior 2x4 braces shall be provided for each window and three sets for each door. 3. Window Assembly — Braces are located horizontally approximately 1/3 of the distance from the top and the bottom of the window. Bolt holes are located 1/3 of the length of the brace from the outside edge of the window jams. Prior to installation, the assembly should be pre -assembled and 3/8" holes (trilled through all of the components. 4. Door Assembly — Door braces will be placed horizontally, one in the center of the doorway and one 1/2 the distance from the center to the top and one 1/2 distance from the center to the bottom of the doorway. Bolt holes are located 1/3 of the length of the brace from the outside edge of the door frame. Prior to installation, the assembly should be pre -assembled and 3/8" holes drilled through all of the components. S. Plywood used to cover exterior openings shall be nailed every 12" along the perimeter of the frame of the window, door, or opening. 6. The 2x4 braces on the 'interior and exterior of the assemblies shall be secured using 3/8" by 12" carriage bolt assemblies. Bolts shall be inserted through the predrilled holes from the exterior with a 1/2" washer place against the exterior brace, a 3/8" washer is placed against the interior brace. The bolt is tightened from the inside so that it slightly compresses the interior brace. The 2x4 Bottom Brace shall be cut to width of door trim and drilled to the floor to prevent opening. 7. Garage Door -- the opening shall be covered with plywood and secured with a minimum of 3 - inch -long deck or wood screws installed on 6 -inch centers around the circumference of the opening. An interior or exterior 2x4 Bottom Brace is required to prevent it from opening and drilled to the floor with masonry screws (or as appropriate). NOTE: These specifications are subject to change upon case by case scenario. Any changes or recommendations shall be discussed during the walk-through of the property prior to a proposal, quote and or notice to proceed. Clty of Santa Ana RFP 17-066 Page Al -3 25G-14