Laserfiche WebLink
<br />© 2020 IRONRIDGE, INC. VERSION 3.2 FLUSH MOUNT INSTALLATION MANUAL - 20 <br />Use IronRidge's Microinverter Kit to bond compatible microstroage <br />devices to the racking system. Insert Microinverter Kit T-bolt into top <br />rail slot. Place compatible microstorage into position and tighten hex <br />nut to 80 in-lbs. <br />Microinverter Kit <br />(80 in-lbs) <br />SYST e MS USING MICROSTORAG e PRODUCTS <br />Insert Frameless Kit T-bolt in top rail slot. Place star <br />washer over T-bolt, allowing it to rest on top of rail. <br />Secure module clamps with a hex nut and torque to 80 <br />in-lbs. <br />Place <br />Star Washer <br />Module Clamp <br />(80 in-lbs)Grounding Lugs <br />Required on Every Rail <br />FRAM e L e SS MODUL e KITS <br />COMPATIBL e PRODUCTS <br />PHAZR <br />PHAZR Devices PHAZR-X, where X is 6-12. <br />Solpad <br />Solpad Inverter model SI-1k <br />Solpad Battery Storage model SB-2K <br />Solpad Junction Box model SJB-4k <br /> ➢Running a separate equipment grounding conductor to the PHAZR or <br />Solpad devices is not required. <br /> ➢If installing in areas with ground snow loads greater than 40 psf and <br />underneath a module, install PHAZR and Solpad devices as close as <br />possible to module frame edge. <br /> ➢Solpad may only be installed on XR-100 and XR-1000 <br /> ➢Solpad may only be installed with modules having a frame thickness of <br />35mm or greater. <br /> ➢Use the number of IronRidge Microinverter kits allowed by the microstorage <br />mounting flange. Some will require 1 kit and others 2 kits. <br />COMPATIBL e PRODUCTS <br />Sunforson <br />Sunforson silver or black SFS-UTMC-200(B) mid and SFS-UTEC- <br />200(B) end clamps. <br />Sunpreme <br />Sunpreme silver or black mid and end clamps with part numbers <br />7500105X where "X" is 1, 5, 6 or 7. <br />Ironridge <br />IronRidge silver or black mid and end clamps with part numbers <br />FMLS-XC-001-Y where "X" is E or M and "Y" is B or blank. <br /> ➢Follow module manufacturer's installation instructions to install <br />the module clamps. <br /> ➢Frameless modules require using a Grounding Lug on every rail. <br /> ➢For Sunpreme Modules Only: If required to use slide prevention <br />hardware, see Module Slide Prevention Addendum (Version <br />1.10). <br />Two sets of two <br />Microinverter Kits <br />(80 in-lbs) <br />Solpad <br />PHAZR <br />3000 S Sycamore St Unit# <br />A- 201822724/29/2024