Laserfiche WebLink
M21 5 Microinverter Quick Install Guide <br />Attach the Microinverters to the PV Racking <br />a. Mark the approximate centers of each PV <br />module on the PV racking. See notes in <br />Step Detai/s on back. <br />4 <br />0, V...,053 <br />b. Mount the microinverters under the PV module, <br />away from rain and sun. Do not mount the <br />microinverter in a position that allows long-term <br />exposure to direct sunlight or in a vertical orientation <br />that allows water to collect in the DC connector <br />recess. <br />c. Torque the microinverter fasteners as follows: <br />• 5Nm (45-50 in-lbs) for 6 mm (1/47 hardware <br />• 9Nm (80-85 in-lbs) for 8mm (5/16") hardware <br />Ground the System <br />a. Route a continuous GEC (grounding electrode <br />conductor) through each of the microinverters to <br />the NEC-approved AC grounding electrode. <br />See notes in Step Detai/s on back. <br />b. Torque each 10/32 grounding cleat screw to <br />2 N m (20-25 in-lbs). <br />f <br /># <br />0 0 <br />0 <br />0 <br />"k <br />GEC- <br />Dress the Cable <br />a. Attach the cabling to the rack using <br />cable clips or tie wraps. <br />b. Dress any excess cabling in loops so that <br />it does not contact the root. <br />cable clip <br />release ho/es <br />Keep the drop /1 <br />connector <br />release holes /-2,4t?j <br />clear and i.-'' <br />accessible. <br />i <br />Connect the Microinverters <br />a. Remove and discard the temporary shipping <br />cap from the cable connector and connect the <br />microinverter. Usten for two clicks as the <br />connectors engage. <br />' F ==1 ' <br />b. Cover any unused connectors with sealing <br />caps. Listen for two clicks as the connectors <br />engage. See notes in Step Details on back. <br />9- <br />L <br />nmi inrlinn 1 /r=h <br />cleat <br />\7)Do not use shipping caps to cover <br />unused connectors. The shipping cap <br />does not provide an adequate <br />environmental seal. <br />(J)