2617 N Deodar St & Unit# 2 - Plan

Home Browse Search

N 4:12 4:12 4:12 4:12 4:12 P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / L P / LP / LP / LP / LP / LP / LP / LP / LP / LP / LP / LP / LP / LP / LP / L 30X22 ATTIC ACCESS 62'-5" 26'-1" 21' 18'-2" 7'-2" 52'-2" 7'-4" 34' 47'-1" 26'-1" 52'-2" 12' 1' 1' MC1 SHEET: SCALE: DATE: 11/25/2024 Revision Table Number Date Revised By Description 1 01/31/2024 JO PLANNING 2 03/08/2024 JO BP 3 04/02/2024 JO PCC 4 11/25/2024 JO PCC COMPA'S DESIGN SERVICES 949 N. IROQUOIS AVE. ANAHEIM, CA 92801 JUAN ORELLANA _____________ (E) ROOF PLAN & MECHANICAL PLAN SCALE: 1/8" = 1'-0" (E) ROOF PLAN & MECHANICAL PLAN (E) ASPHALT SHINGLE 4 1 2 3 INTAKE LOW PROFILE VENT SHADOWHAWK - LOW PROFILE VENT LPG12 EXHAUST SHINGLE VENT 5ATTIC VENT CALCULATION MECHANICAL NOTES 1.) DUCTS PENETRATING WALL OR CEILING SEPARATIONS BETWEEN A GARAGE AND A DWELLING UNIT SHALL BE CONSTRUCTED OF MINUM 26 GAGE SHEET METAL AND SHALL HAVE NO OPENINGS INTO THE GARAGE. 2.) EACH BATHROOM CONTAINING A BATHTUB, SHOWER OR TUB/SHOWER COMBINATION SHALL BE MECHANICALLY VENTILATED FOR PURPOSES OF HUMIDITY CONTROL IN ACCORDANCE WITH CMC, CHAPTER 4 AND CGBSC, CHAPTER 4, DIVISION 4.5 HUMIDITY CONTROL SHALL BE CAPABLE OF ADJUSTMENT BETWEEN A RELATIVE HUMIDITY RANGE OF LESS THAN OR EQUAL TO 50% TO A MAXIMUM OF 80%. 3.) A COMPRESSOR OR PORTION OF A CONDENSING UNIT SUPPORTED FROM THE GROUND SHALL REST ON A CONCRETE OR OTHER APPROVED BASE EXTENDING NOT LESS THAN 3 INCHES ABOVE THE ADJOINING GROUND LEVEL. 4.) CONDENSATE LINES FROM MECHANICAL EQUIPMENT SHALL DISCHARGE TO A PLUMBING FIXTURE OR STORM DRAIN BY MEANS OF AN INDIRECT WASTE PIPE. CONDENSATE LINES SHALL NOT DRAIN OVER A PUBLIC WAY. 5.) HOUSEHOLD COOKING APPLIANCES SHALL HAVE A VERTICAL CLEARANCE ABOVE THE COOKING TOP OF NOT LESS THAN 30 INCHES TO COMBUSTIBLE MATERIAL OR METAL CABINETS. 6.) A. THE DISTANCE FROM THE PASSAGEWAY ACCESS TO THE FURNACE SHALL NOT EXCEED 20 FEET MEASURED (FOR HEAD HEIGHT LESS THAN 6 FEET) ALONG THE CENTERLINE OF THE PASSAGEWAY. B. THE PASSAGEWAY SHALL BE UNOBSTRUCTED AND SHALL HAVE SOLID FLOORING NOT LESS THAN 24 INCHES WIDE FROM THE ENTRANCE OPENING TO THE APPLIANCE. C. A LEVEL WORKING PLATFORM NOT LESS THAN 30 INCHES BY 30 INCHES SHALL BE PROVIDED IN FRONT OF THE SERVICE SIDE OF THE APPLIANCE D. A PERMANENT 120-VOLT RECEPTACLE OUTLET AND A LIGHTING FIXTURE SHALL BE INSTALLED NEAR THE APPLIANCE. THE SWITCH CONTROLLING THE LIGHT SHALL BE LOCATED NEAR THE ENTRANCE TO THE PASSAGEWAY 7. ) A COMPRESSOR OR PORTION OF A CONDENSING UNIT SUPPORTED FROM THE GROUND SHALL REST ON A CONCRETE OR OTHER APPROVED BASE EXTENDING NOT LESS THAN 3 INCHES ABOVE THE ADJOINING GROUND LEVEL 8.) A SEDIMENT TRAP IS TO BE PROVIDED AT THE LOCATION OF THE WATER HEATER AND THE FAU OR WHERE A SEDIMENT TRAP IS NOT INCORPORATED AS PART OF THE APPLIANCE. A SEDIMENT TRAP MUST BE INSTALLED DOWNSTREAM OF THE APPLIANCE SHUTOFF VALVE AS CLOSE TO THE INLET OF THE APPLIANCE AS PRACTICAL, BUT BEFORE THE FLEX CONNECTOR, WHERE USED AT THE TIME OF APPLIANCE INSTALLATION. SEDIMENT TRAPS ARE NOT REQUIRED AT RANGES, CLOTHES DRYERS, DECORATIVE VENTED APPLIANCES, OR GAS FIREPLACES. 9.) CARBON MONOXIDE ALARMS SHALL BE INTERCONNECTED SO THAT THE ACTIVATION OF ONE ALARM ACTIVATES ALL OF THE ALARMS. (CRC R315.7) 10.) REFRIGERANT SERVICE PORTS LOCATED OUTDOORS SHALL BE FITTED WITH LOCKING-TYPE TAMPER- RESISTANT CAPS\ (CMC 1106.14) 11) LAUNDRY CLOSET A. PROVIDE CLOTHES DRYER MOISTURE EXHAUST DUCT (MIN, 4INCH DIA. MADE OF METAL WITH SMOOTH INTERIOR SURFACE) THAT TERMINATES TO THE OUTSIDE AND EQUIP WITH A BACK - DRAFT DAMPER. EXHAUST DUCT LENGTH IS LIMITED TO 14 FT. WITH 2 ELBOWS SHOW THE DUCT AND TERMINATION LOCATION ON THE PLANS. (CMC 504.3). B. PROVIDE 1SQ. INCH PER 1,000 BTU/hr. GAS APPLIANCE INPUT RATING (100 SQ. IN. MINIMUM) OF MAKEUP AIR TO LAUNDRY ROOM PER CMC 504.3.2 & CMC 701.3.1. PROVIDE ANALYSIS ON THE PLANS TO JUSTIFY SIZE. 12) KITCHEN RANGE HOODS - SHALL BE INSTALLED FOR COOKING FACILITIES WITH AN APPROVED FORCED - DRAFT SYSTEM OF VENTILATION VENTED TO THE OUTSIDE OF THE BUILDING. DUCTS USED FOR DOMESTIC KITCHEN RANGE VENTILATION SHALL BE OF METAL, OR OTHER APPROVED MATERIAL AND SHALL HAVE SMOOTH INTERIOR SURFACES. DUCTS FOR DOMESTIC RANGE HOODS SHALL ONLY SERVE COOKING APPLIANCES. (CMC 504.3; § 150.0(o)1G, 2B)). A) KITCHEN VENTED RANGE HOODS - i. HERS VERIFICATION OF AIRFLOW AND SOUND RATINGS. ii. MINIMUM AIRFLOW OF 280 CFM. iii. MAXIMUM SONE RATING OF 3.0. 13) BATHROOM EXHAUST FAN(S) SHALL BE OF THE FOLLOWING: A)MIN 50 CFM. B) ENERGY STAR COMPLIANT. C) BE DUCTED TO TERMINATE OUTSIDE THE BUILDING. D) BE RATED FOR SOUND AT A MAXIMUM OF 3 SONE. E) SWITCHED SEPARATELY FROM LIGHTING. EXHAUST SHINGLE VENT EXHAUST ROOF VENT (N) ROOF EXHAUST VENTS. PROVIDE MIN. OF 2 PER CALCS 2 MC1 2 MC1 (N) ROOF LOW PROFILE INTAKE VENTS. PROVIDE MIN. OF 3 UNITS 1 MC1 1 MC1 ATTIC VENT CALCULATION : 387 SQ. FT / 300= 1.29 * 144= 185.76 SQ. IN. AIR VENT INC. VENTS ARE SHOW AS REFERENCE ONLY, SIMILAR VENTS CAN BE USED AS LONG AS IT MEETS THE INCHES NET FREE PER LINEAR FOOT REQUIRED 1/8" = 1'-0" PROJECT NAME: MANUEL & MARIA CASAS MAIN HOUSE ADDRESS: 2617 DEODAR ST., SANTA ANA, CA 92705 ADU ADDRESS: 2617 DEODAR ST. UNIT #2, SANTA ANA, CA 92705 THE KITCHEN EXHAUST HOOD SHALL PROVIDE A MINIMUM AIRFLOW RATE OF 280 CFM, AS PER CEnC TABLE 150.0-G, FOR A FLOOR AREA OF 430 SQ. FT. SEE NOTE 12 FROM MECHANICAL NOTES.