505 E Central Ave #B - DEF 1 - Plan

Home Browse Search

CITY OF SANTA ANA SPECIFICATIONS PROJECT NO.: XX-XXXX PROJECT TITLE 203 9.03 INSPECTIONS At the time of electrical inspections, the Contractor shall make available a complete set of working drawings showing progress to date and detail variations from the plans. All variations must have prior approval of the Engineer. 9.04 MATERIALS AND WORKMANSHIP Materials and workmanship, unless indicated or specified otherwise, shall be in strict conformity with standards of the latest editions including revisions of the Electrical Code of the County, National Electric Code (2010) of the National Board of Fire Underwriters, CAL/OSHA, Electrical Safety Orders, and the Standards of the National Electrical Manufacturers Association. Nothing in these plans or specifications shall be construed to permit work bellow the standards of these ordinances and those of OSHA. After acceptance of the contract, all work found which does not conform or comply with the applicable code shall be brought into conformance at no cost to the Agency. 9.05 PROPOSED SUBSTITUTIONS AND “OR EQUAL” Equipment and wiring shown on the Plans is for materials as specified. Should equipment of other manufacturers be approved for use, the Contractor shall make all changes in other equipment, conduit, wiring, or location of equipment that may be required due to design or space allotment, as approved by the Engineer, without charge to the Agency. It is the Contractor’s responsibility to show that all products proposed for substitution are equal to the specified item by submitting sufficient information to permit a comparative check. The term “equal” shall mean that the product or material offered shall have equivalent or more value to the Agency based on the value of the item set forth in the specifications or on the Plans, and then only after the Contractor’s written submittal has been approved in writing. If, after installation, substituted equipment is found to be not equal to that specified, that equipment shall be replaced with approved item(s) at no cost to the Agency. 9.06 DRAWINGS PERFORMANCE All scale dimensions are approximate. Before proceeding with any work, the Contractor shall check and verify all locations and dimensions of equipment at the site of work. All work specified, but not clearly defined by the drawings, must be installed as directed by the Engineer in a manner satisfactory to him. Work covered by notes on drawings must be furnished and installed, whether or not it is specifically mentioned in these specifications. The contract Drawings indicated the extent and general arrangement of the new existing equipment, conduit and wiring systems, and essentially diagrammatic. The drawings indicate the required sizes and points of termination of conduits and wires and routes to to avoid obstructions and provided clearance; necessary offsets, etc., and t shall be the 505 E Central Ave #B11/6/2024