Laserfiche WebLink
ST. BARBARA CATHOLIC SCHOOL TASK 2 75-24272-01 <br />DIOCESE OF ORANGE SEPTEMBER 12TH, 2024 <br />SANTA ANA, CA BID & PERMIT SET <br /> <br />PROJECT MANAGEMENT AND COORDINATION 013100 - 3 <br />1.6 COORDINATION DRAWINGS <br />A. Coordination Drawings, General: Prepare coordination drawings according to requirements in <br />individual Sections, and additionally where installation is not completely indicated on Shop <br />Drawings, where limited space availability necessitates coordination, or if coordination is <br />required to facilitate integration of products and materials fabricated or installed by more than <br />one entity. <br />1. Content: Project-specific information, drawn accurately to a scale large enough to <br />indicate and resolve conflicts. Do not base coordination drawings on standard printed <br />data. Include the following information, as applicable: <br />a. Use applicable Drawings as a basis for preparation of coordination drawings. <br />Prepare sections, elevations, and details as needed to describe relationship of <br />various systems and components. <br />b. Indicate functional and spatial relationships of components of architectural, <br />structural, civil, mechanical, and electrical systems. <br />c. Indicate space requirements for routine maintenance and for anticipated <br />replacement of components during the life of the installation. <br />d. Show location and size of access doors required for access to concealed dampers, <br />valves, and other controls. <br />e. Indicate required installation sequences. <br />f. Indicate dimensions shown on Drawings. Specifically note dimensions that appear <br />to be in conflict with submitted equipment and minimum clearance requirements. <br />Provide alternative sketches to Architect indicating proposed resolution of such <br />conflicts. Minor dimension changes and difficult installations will not be <br />considered changes to the Contract. <br />B. Coordination Drawing Organization: Organize coordination drawings as follows: <br />1. Floor Plans and Reflected Ceiling Plans: Show architectural and structural elements, and <br />mechanical, plumbing, fire-protection, fire-alarm, and electrical Work. Show locations of <br />visible ceiling-mounted devices relative to acoustical ceiling grid. Supplement plan <br />drawings with section drawings where required to adequately represent the Work. <br />2. Plenum Space: Indicate sub-framing for support of ceiling and wall systems, mechanical <br />and electrical equipment, and related Work. Locate components within plenums to <br />accommodate layout of light fixtures and other components indicated on Drawings. <br />Indicate areas of conflict between light fixtures and other components. <br />3. Mechanical Rooms: Provide coordination drawings for mechanical rooms showing plans <br />and elevations of mechanical, plumbing, fire-protection, fire-alarm, and electrical <br />equipment. <br />4. Structural Penetrations: Indicate penetrations and openings required for all disciplines. <br />5. Slab Edge and Embedded Items: Indicate slab edge locations and sizes and locations of <br />embedded items for metal fabrications, sleeves, anchor bolts, bearing plates, angles, door <br />floor closers, slab depressions for floor finishes, curbs and housekeeping pads, and <br />similar items. <br />6. Mechanical and Plumbing Work: Show the following: <br />a. Sizes and bottom elevations of ductwork, piping, and conduit runs, including <br />insulation, bracing, flanges, and support systems.