Laserfiche WebLink
ST. BARBARA CATHOLIC SCHOOL TASK 2 75-24272-01 <br />DIOCESE OF ORANGE SEPTEMBER 12TH, 2024 <br />SANTA ANA, CA BID & PERMIT SET <br /> <br />QUALITY REQUIREMENTS 014000 - 9 <br />2. Determine the locations from which test samples will be taken and in which in-situ tests <br />are conducted. <br />3. Conduct and interpret tests and inspections and state in each report whether tested and <br />inspected work complies with or deviates from requirements. <br />4. Submit a certified written report, in duplicate, of each test, inspection, and similar <br />quality-control service through Contractor. <br />5. Do not release, revoke, alter, or increase the Contract Document requirements or approve <br />or accept any portion of the Work. <br />6. Do not perform duties of Contractor. <br />E. Manufacturer's Field Services: Where indicated, engage a factory-authorized service <br />representative to inspect field-assembled components and equipment installation, including <br />service connections. Report results in writing as specified in Section 013300 "Submittal <br />Procedures." <br />F. Manufacturer's Technical Services: Where indicated, engage a manufacturer's technical <br />representative to observe and inspect the Work. Manufacturer's technical representative's <br />services include participation in pre-installation conferences, examination of substrates and <br />conditions, verification of materials, observation of Installer activities, inspection of completed <br />portions of the Work, and submittal of written reports. <br />G. Associated Contractor Services: Cooperate with agencies and representatives performing <br />required tests, inspections, and similar quality-control services, and provide reasonable auxiliary <br />services as requested. Notify agency sufficiently in advance of operations to permit assignment <br />of personnel. Provide the following: <br />1. Access to the Work. <br />2. Incidental labor and facilities necessary to facilitate tests and inspections. <br />3. Adequate quantities of representative samples of materials that require testing and <br />inspection. Assist agency in obtaining samples. <br />4. Facilities for storage and field curing of test samples. <br />5. Delivery of samples to testing agencies. <br />6. Preliminary design mix proposed for use for material mixes that require control by testing <br />agency. <br />7. Security and protection for samples and for testing and inspection equipment at Project <br />site. <br />H. Coordination: Coordinate sequence of activities to accommodate required quality-assurance and <br />quality-control services with a minimum of delay and to avoid necessity of removing and <br />replacing construction to accommodate testing and inspection. <br />1. Schedule times for tests, inspections, obtaining samples, and similar activities. <br />1.12 SPECIAL TESTS AND INSPECTIONS <br />A. Special Tests and Inspections: Conducted by a qualified testing agency or special inspector as <br />required by authorities having jurisdiction, as indicated in individual Specification Sections, and <br />as follows: