BUILDING NETWORKS, INC. - Laserfiche WebLink

Home Browse Search

";',tkt�XkBUILDING ::': NETWORKS 9. Assumes existing utility services (electrical, domestic water, chilled water, sanitary, fire sprinkler, existing HVAC service, etc.) are sufficient size and quality for use for the proposed improvements. Upgrades to existing utilities and base building infrastructure are not included unless otherwise noted. 10. Up-to-date backgrounds in AutoCAD format to be provided by Architect. Backgrounds to include floor plans, reflected ceiling plan, power and communication plans, and roof plan (if mechanical or plumbing roof work is required) at a minimum. 11. Scope of work does not include envelope improvements unless otherwise noted. 12. Scope of work does not include demolition permits or plans for demolition unless otherwise noted. 13. Construction phasing is not included and is considered contractor means and methods. 14. Temporary provisions (e.g. temp power, temp HVAC, etc.) are considered means and methods and not included in the base scope of work. 15. Submission to authorities having jurisdiction by others. Response to comments for MEP drawings included. 16. Fire sprinkler and fire alarm design, where provided, will be performance specification only for deferred approval by authority having jurisdiction and permit documentation is design -build by others. 17. Reimbursable estimates do not Include prints for owner, contractor, or others. 18. Reimbursable estimates do not include plan check fees. 19. All landlord and/or owner requirements to be provided prior to the start of work. 20. Arc flash and coordination studies are assumed to be by installing contractor. 21. Engineer will be provided a minimum of ten (10) working days for shop drawing and submittal review. Reduced turnaround times will be considered project acceleration and are subject to additional fees. The review is not intended to verify the accuracy and completeness of details such as dimensions and quantities orto substantiate installation iristructions or performance of equipment or systems, all of which is the responsibility of the Contractor. 22. Engineer will be provided a minimum of five (5) working days for request for information (RFI) review. Reduced turnaround times will be considered project acceleration and are subject to additional fees. If, with undue frequency, the Contractor requests information that is obtainable through reasonable examination and comparison of the Contract Documents, site conditions, and previous correspondence, interpretations, or clarifications, the Consultant shall be entitled to additional compensation. 23. Construction administration does not include review of substitutions or value engineering proposed by others. 24. Bid support is limited to response to bidders' questions. Attendance at a dedicated bid walk is not included unless explicitly stated elsewhere in this Proposal. 25. Bid leveling is not included but may be provided as an additional service. 26. LEED design and administration services are explicitly excluded from the scope of work. 27. Cost estimating and review of cost estimates are not included in the base scope of work. 28. Construction phase services shall be considered complete upon receipt of certificate of occupancy or sixty (60) days from substantial completion whichever occurs sooner. HVAC Life Cycle Replacement Scoping Study Page 13 City of Santa Ana Revised 07/07/2020