NS-793 - Laserfiche WebLink

Home Browse Search

PORTABLE HEATING APPLIANCE - Any approved unvented air heating appliance designed for human comfort which is not secured or attached to a building by any means other than by fuel piping or electrical wiring. READILY ACCESSIBLE - Capable of being reached safely and quickly for operation, repair, or inspection without requiring those to whom ready access is requisite to climb over, or remove obstacles, or to resort to the use of a portable ladder, etc. RESIDENTIAL BUILDING - A building or portion thereof de- signed or used for human habitation. RISER HEAT PIPE - AnT duct which extends at an angle of more than 45 degrees from the horizontal. Exception: This definition shall not include any boot connection. SMOKE PIPE - A pipe or passageway, constructed of iron or steel, or of other material acceptable to the Department, which connects a fuel combustion chamber with a chimney. Note: This definition shall not include a gas vent connector. VENT COLLAR - The outlet opening of an appliance provided for connection of the vent system. VENTED WALL FURNACE - A self-contained, vented comfort heating appliance designed for incorporation in, or permanent attachment to a wall, floor, ceiling or partition, and arranged to furnish heated air by gravity or by a fan directly into the space to be heated. Note: This definition shall not include floor furnaces, unit heaters and room heaters. WARM AIR FURNACE - A comfort heating appliance designed or arranged to discharge heated air through any duct or ducts. Note: This definition shall not include a unit heater. WARM AIR HEATING CONTRACTOR - Any person holding a valid State Contractor's License C-20 or SC-20. WELDED JOINT OR SEAM - Any joint or seam obtained by the joining of metal parts in the plastic or molten state. SECTION 8810. Location of Forced Air Type Central Furnaces, Section 703(a) is amended by inserting an asterisk (*~ after the word "furnace" in the second and third lines of paragraph 1 and add at the bottom of Page 29 "*Except one side and the back may be of lesser clearance if so listed." SECTION 8810.1. Location of Forced Air Type Central Furnaces. Paragraph 6 of Section 703(a) is amended to read as follows: 6. Furnace installations on roofs shall be of a type approved for outdoor installation or sufficiently protected by a covering to maintain proper operation under all adverse weather cond~*~nns. Fire separation between the roof deck, attic, furred space or other occupancy shall be not less than one (1) hour rating unless approved for installation on combustible floors. No such installation shall be made within five (5) feet of any property line or within thirty (30) inches of any vertical projection wall, bank, sign, window air intake or other obstructions. SECTION 8810.2. Location of Forced Air Type Central Furnaces. Section 703 is amended by redesignating paragraphs 703(a) 5, 6, and 7 as subsections 703(b), (c), and (d), respectively. SECTION 8811. Access to Forced Air Type Central Furnaces. Subsection 704(e) is amended to read as follows: (e) By a cleated walkway not less than twenty-four (24) inches wide. Access to such walkway shall be by ladder or stairs complying with the provisions of this Section. -26-